A-frame Monitor Arm



The A-frame arm was specifically developed  for healthcare environments. It integrates seamlessly with point of care solutions located at the patients' bedside. It offers a 1500 mm reach and very high vertical movement. Its balance is perfect and re-positioning is quick and easy. Wiring is built into the monitor arm, not pulled through. This allows for use of cabling with large connectors, like HDMI, without modification.

 


  

Specifications

Material Alumium
Colour White
Mounting With male spigot
Technology Parallel three-pivot arm
Arm lengths 150 cm
Load capacity 1 kg to 7 kg
Maximum total cable diameter       10 mm

NB: Low loads may require an extra weight for balance.


 

 

Design

The manufacturer makes the A-frame monitor arm to order. This arm is a self balancing arm with internal gas springs. The gas springs require careful calibration to match the weight they need to carry. When calibrated correctly, the arm will last for more than 30.000 cycles.

The design of the arm protects all the internal wiring. It minimizes stress and potential cable pinching. If needed, a spring balanced VESA mount version is available upon request. The covered A-frame monitor arm is easy to clean and conforms to healthcare standards. 

Maximum vertical and horizontal movement

The A-frame monitor arm's design maximizes horizontal and vertical movement. It provides optimal horizontal reach and always stays in the right position without drifting. The arm has a virtually maintenance free construction.

 


 

 

SHARE THIS PAGE